Now in Wordbee, you can check that terms have been correctly translated according to the memories and glossaries attached to your projects.
How does it work?
To enable this option, you should first reach the resources tab of your project and tick the bubble under QA, as follows:
In a second step, you should just activate the Terminology check option in your QA profile:
But when the Terminology check take effect?
During view segment or manual translation or pre-translation?
Hi Rong,
Whenever you run the Quality Assurance (QA) check. So I'd say typically when your translation is finished. Yoou may want to read the following article about QA.
Kind regards,
Brahim
very helpful ! thank you !
@Brahim Aïoun, (Hope you can see my comments).
The link that you mentioned above seems not work anymore...could you please provide the new link again? Thank you!
4 Comments